Asepco Logo go to home page
 
Advanced Aseptic Process Equipment
separator

ASEPCO Close-Couple Vessel Connectors

QUICKONNECT™

Quickonnect pic

ASEPCONNECT™

mixer

Revolutionary designs to make your life easier

ASEPCO close connects are alternatives to hygienic clamps and Ingold ports for connecting flush-mounted probes, instruments, and valves to tanks. The ASEPCO close connects are also easier to install and to clean than the alternatives.

All of our close connects have ASEPCO's patented aseptic seal, which is based on the same reliable seal that you find in our valves.

Standard Features

  • Our patented sealing face improves gasket sealing edge
  • Flush-mounted to tank, thereby eliminating dead legs and leakage
  • Large outside diameter to avoid warping (other diameters available)
  • Available in 316L, AL6XN, Hastelloy C-22, C-276 materials and several finishes
  • Easy to place, seal, and inspect for ensure complete isolation of process fluids

In addition, to maintain the service level you have come to expect from ASEPCO, we carry stock in most sizes.
We can also provide custom thicknesses and tank ID angles.

 

Close-connects on tank

QUICKONNECT™

 

ASEPCONNECT™

Quickonnect apart

 

asepconnect in parts

quickonnect callouts   asepconnect callouts
  • For super-fast change out of instruments–no tools required
  • Available in sizes 3/8 inch to 4 inches
  • Tri-clamp connection provides quick product changeover
  • Galling is not a concern with this connector because there are no threaded parts
 
  • Available in sizes 3/8 inch to 4 inches
  • Monel studs eliminate galling
 

Standard ASEPCO Close-Couple Vessel Connector Specifications

   Material
316L, AL6XN, Hastelloy C-22, C-276
   Finish
20 microinch Ra max.
15 microinch Ra max.
10 microinch Ra max.
   Design Pressure
-14.5 to 101.5 psig
(Maximum working pressure is determined by the design
pressure of the gasket being used in the assembly.)
  Design Temperature
-80 to 200 C
(Maximum working temperature is determined by the design
temperature of the gasket being used in the assembly.)
  Marking
All connectors are marked for heat traceability
according to ASEPCO’s ISI QA Program